 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-360-34-2
(11) Rotate carrier housing (6) so bearing
cover (5) bore is parallel to ground.
(12) Coat taper bearing (11) with lubricating oil.
(13) Install pinion shaft (13) in carrier housing
(6).
(14) Install taper bearing (14) on pinion shaft
(13) while assistant supports pinion shaft
(13).
(15) Position carrier housing (6) so pinion shaft
(13) is parallel to floor.
(16) Position jet extractor (15) between
housing (6) and teeth on pinion gear (16)
with aid of assistant.
WARNING
Adhesive-sealant can bum easily, can
give off harmful vapors, and Is
harmful to skin and clothing. To
avoid Injury or death, keep away from
open fire and use In well-ventilated
area. If sealing compound gets on
skin or clothing, wash Immediately
with soap and water.
(17) Coat new nut (17) with adhesive-sealant
(Item 4, Appendix B).
(18) Install new nut (17) on pinion shaft (13)
flat side first.
(19) Tighten nut (17) to 528-564 lb-ft (716-765
Nm).
(20) Stake edge of nut (17) in notches in pinion
shaft (13).
(21) Remove jet extractor (15) from housing
(6).
25-17
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals