 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-360-34-2
(20) Install differential carrier preload gage (22)
on bearing cap (20) with screw (24).
(20.1) Position magnetic base of dial indicator
(23) on bearing cap (20).
(20.2) Position probe of dial indicator (23) on
differential carrier preload gage (22).
(20.3) Zero dial indicator (23).
(21) Tighten adjusting nut (21) until bearing
caps (20) expand 0.013-0.017 in. (.33-.43
mm).
(21.1) Remove screw (24), differential carrier
preload gage (22) and dial indicator (23)
from bearing caps (20).
(22) Tighten capscrews (19) to 125 Ib-ft (169
Nm).
(23) Coat capscrew (24) with adhesive-sealant.
(24) Install capscrew (24) in lockplate (25) and
bearing cap (20). Torque to 132-216 lb-in.
(14.9-24.4 Nm).
(25) Check backlash of differential (15) to
pinion shaft (5).
(26) Hold yoke (11) so that pinion gear (26)
does not move.
NOTE
Do not allow pinion gear to turn while
doing steps (27) thru (29).
(27) Turn differential (15) counterclockwise
until it stops to take up backlash.
NOTE
Shaft from dial indicator must be at
right (90) angle to face of tooth when
in contact.
(28) Install dial indicator (22) on face of
differential gear tooth (27).
(29) Turn differential (15) clockwise until it
stops.
NOTE
Backlash should be 0.010-0.013 in.
(0.25-0.33
mm).
To
increase
backlash, reduce thickness of shim.
To decrease backlash, increase
thickness of shim.
(30) Record differential (15) to pinion shaft (5)
backlash measured on dial indicator (22).
Change 2 24-11
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals