 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-360-34-2
(52)
Coat lower bearing outer race (60) with
grease.
(53)
Install lower bearing outer race (60) in
transfer case rear half (48).
WARNING
Be careful not to trap hands between
gear assembly and transfer case.
Injury to personnel may result.
(54)
Install rear output shaft assembly (61) in
transfer case rear half (48) through lower
bearing outer race (60).
(55)
Coat upper bearing race (62) with grease.
NOTE
Do step (56) if bearing race was
removed.
(56)
Install upper bearing outer race (62) in
bearing retaining plate (63).
WARNING
Adhesive-sealant can burn easily,
can give off harmful vapors, and is
harmful to skin and clothing. To
avoid injury or death, keep away from
open fire and use in well-ventilated
area. If adhesive-sealant gets on skin
or clothing, wash immediately with
soap and water.
(57)
Coat threads of six screws (64) with
adhesive-sealant (Item 6, Appendix B).
(58)
Install bearing retaining plate (63) on
transfer case rear half (48) with six
washers (65) and screws (64). Torque to
88 lb-ft (119 Nm).
(59)
Turn transfer case rear half (48) over so
outside surface faces up.
(60)
Install screw (66 ) in lower rear output
shaft (23).
(61)
Lightly tap down on lower rear output
shaft (23) to seat bearings.
(62)
Install dial indicator (67) on rear output
shaft (23).
(63)
Pry up on screw (66).
23-23
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals