 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-360-34-2
NOTE
There are two thickness' of steel
plates.
(10) Measure thickness of one tang (6) on
each of seven steel plates (2). Thin plates
should measure 0.096-0.103 in. (2.44-
2.62 mm). Thick plates should measure
0.116-0.123 in. (2.95-3.12 mm).
(11) Replace friction plate thickness is less
than 0.1347 in. (3.420 mm)
(12) Repeat steps (6 ) thru (8) to recheck
second clutch thickness.
(13) Check friction plate for presence of oil
grooves.
(14) Remove second clutch piston (4), steel
plates (2), and friction plates (3) from
press.
d. Assembly
(1) Install dowel pins (1 and 2) and lube plug
(3) in adapter housing (4).
(2) Install 28 springs (5) in clutch piston (6).
(3) Install clutch ring (7) on clutch piston (6).
(4) Install four new retaining washers (8)
while applying pressure to clutch ring (7).
(5) Coat seal rings (9 an d 10) with lubricating
oil.
(6) Install inner seal ring (9) and outer seal
ring (10) in clutch piston (6).
(7) Install clutch piston (6) in adapter housing
(4).
Change 3 22-110.1 (22-110.2 blank)
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals