 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-360-34-2
d. Assembly
(1) Position rear cover (1) flange side up.
Use wooden block for support.
(2) Coat new inner seal ring (2) and new
outer seal ring (3) with lubricating oil.
(3) Install new inner seal ring (2) and new
outer seal ring (3) on first clutch piston (4)
with lips facing down.
(4) Install first clutch piston (4) in rear cover
(1) using seal protector (5).
NOTE
Do step (5) only if dowel pins were
removed.
(5) Install two dowel pins (6 and 7) in rear
cover (1).
(6) Install vent tube (8) on rear cover (1).
(7) Install 30 piston release springs (9) in first
clutch piston (4).
(8) Install piston spring retainer (10) on piston
release springs (9).
(9) Push down on piston spring retainer (10)
and piston release springs (9) using clutch
spring compressor tool (11). Press until
retaining ring groove in rear cover (1) is
cleared.
WARNING
Wear eye protection and use care
when installing retaining rings.
Retaining rings are under spring
tension and can act as projectiles
when released causing severe eye
injury.
(10) Install retainin g ring (12). Remove clutch
spring compressor tool (11).
22-103
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals