 |
|||
|
|
|||
|
Page Title:
PLANETARY GEARING, SHAFTS, AND THIRD CLUTCH REPAIR (CONT) |
|
||
| ||||||||||
|
|
 TM 9-2320-360-34-2
b. Disassembly
Gear Unit and Main Shaft
(1) Remove center sun gear shaft (1) and
main shaft (2) from front carrier assembly
(3).
(2) Remove center sun gear shaft (1) from
main shaft (2).
(3) Remove thrust washer (4) from base of
main shaft (2). Discard thrust washer.
NOTE
Remove lube orifice plug only if
required.
(4) Remove lube orifice plug (5) from main
shaft (2).
(5) Remove front sun gear (6) from front
carrier assembly (3).
(6) Remove two thrust washers (7) from front
carrier assembly (3).
Discard thrust
washers.
WARNING
Wear eye protection and use care
when Installing retaining rings.
Retaining rings are under spring
tension and can act as projectiles
when released causing severe eye
Injury.
(7) Remove retaining ring (8) and front ring
gear (9) from planetary connecting drum
(10).
(8) Remove center carrier assembly (11) from
connecting drum (10).
(9) Remove snap ring (12) from rear sun gear
(13) and center ring gear (14).
(10) Remove rear sun gear (13) from center
ring gear (14).
(11) Remove bearing race (15), bearing (16),
and bearing race (17) from rear carrier
assembly (18).
(12) Remove bearing (19) from rear carrier
assembly (18).
22-85
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals