 |
|||
|
|
|||
|
Page Title:
PLANETARY GEARING, SHAFTS, AND THIRD CLUTCH REPAIR (CONT) |
|
||
| ||||||||||
|
|
 TM 9-2320-360-34-2
22-16. PLANETARY GEARING, SHAFTS, AND THIRD CLUTCH REPAIR (CONT)
WARNING
Wear eye protection and use care
when Installing retaining rings.
Retaining rings are under spring
tension and can act as projectiles
when released causing severe eye
injury.
NOTE
Backing plate is color-coded green
and thicker than six steel plates.
(5) Remove retaining ring (7), backing plate
(8), six friction plates (9), and six steel
plates (10) from transmission housing (4).
Tie third clutch plates together and identify
the pack.
(6) Lift center planetary ring gear (11) and
rear sun gear (12) from transmission
housing (4).
WARNING
Do not lift the rear planetary
assembly by the ball bearing on the
rear end. The bearing may come off
and the heavy planetary may fall.
Failure to comply with this warning
may result In personal injury or
damage to equipment.
CAUTION
Output shaft yoke must be turned
while lifting rear planetary carrier
assembly
out
of
transmission
housing. Failure to comply will not
allow rear carrier assembly to be
removed and may cause equipment
damage.
(7) Install lifting tool (13) on rear planetary
carrier assembly (14) and lift assembly
from transmission housing (4) with
suitable lifting device.
(8) Place rear planetary carrier assembly on
flat work surface. Remove lifting tool (13).
22-84
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals