 |
|||
|
|
|||
|
Page Title:
MAIN CONTROL VALVE REPAIR (CONT) |
|
||
| ||||||||||
|
|
 TM 9-2320-360-34-2
22-14. MAIN CONTROL VALVE REPAIR (CONT)
(4) Remove screw (8) and selector detent
assembly (9) from main control valve (2).
(5) Remove two screws (10) and washers
(11) from main control valve (2).
CAUTION
Ensure selector valve is secured
before removing control valve,
otherwise it could fall out and
become damaged.
(6) Remove main control valve (2) from
transmission (1) while holding selector
valve (12).
(7) Place main control valve (2) on flat work
surface bottom up.
b. Disassembly
(1) Remove three screws (1) from modulator
valve body (2).
(2) Remove modulator valve body (2) while
holding oil transfer plate (3) and separator
plate (4) together on control valve body
(5).
WARNING
All valves are under spring tension.
Release springs slowly to avoid
personal Injury.
CAUTION
Do not use magnets to remove
valve bodies. Magnetized valve
bodies may not work properly.
Mark positions of adjusting rings
before
removal.
Improper
shifting and possible damage to
transmission may result if not
assembled to same notch.
NOTE
Tag and
mark
all
parts
after
removing.
(3) Press adjusting ring (6) inward and
remove retaining pin (7) from modulator
valve body (2).
(4) Remove adjusting ring (6), spring (8),
modulator valve (9), and valve actuator
pin (10) from modulator valve body (2).
22-64
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals