BLOWER REPAIR (cont.) -726030160

TM 9-2320-360-34-2

(64) Remove four screws (28) and washers (27) from

front end plate (6).

(65) Install coupling spacer (34) on rotor (9) at front

end plate (6).

(66) Position fuel pump disk (35), new keywasher

(36), and screw (37) on rotor (9).

(67) Bend one tang of keywasher (36) into slot on

fuel pump disk (35).

(68) Tighten screw (37) on rotor (9) to 65 lb-ft (88

Nm).

(69) Bend two tangs of keywasher (36) around head

of screw (37).

NOTE

Front cover screws are shorter than

rear cover screws.

(70) Install new gasket (38) and front cover (39) on

front end plate (6) with 10 washers (40), new

lockwashers (41), and screws (42). Torque to

156-204 lb-in. (17.6-23.0 Nm).

NOTE

When properly positioned, spring

plates will mount on machined side

of coupling.

(71) Position two spring plates (43) on coupling (44)

with three screws (45). Do not tighten.

(72) Place coupling (44) in soft-jawed vise. Tighten

screws (45) to 30 lb-ft (41 Nm).

20-15