BLOWER REPAIR (cont.) -726030152

TM 9-2320-360-34-2

(35) Place front end plate (41) on wooden blocks with

seal (55) up.

(36) Place long end of remover and Installer tool (56)

in right bore (57), through seal (55), and into

roller bearing (58).

(37) Remove roller bearing (58), collar (59), and seal

(55) from right bore (57). Discard seal.

(38) Install collar (59) In left roller bearing (60) for

support.

(39) Install long end of remover and installer tool (56)

In left bore (61) of front end plate (41) through

roller bearing (60).

(40) Remove roller bearing (60) from left bore (61).

(41) Remove two plugs (62) from front end plate (41).

(42) Place rear end plate (5) on wooden blocks with

seal (63) up.

(43) Install long end of remover and installer tool

(561 in bore (64), through seal (63), and into ball

bearing (65).

(44) Remove ball bearing (65) and seal (63) from

bore (64).

(45) Repeat steps (42) thru (44) for remaining bore

(66).

b. Cleaning/Inspection

(1) Inspect dowel pins (1) for breakage or damage.

Replace if broken or damaged.

WARNING

Dry cleaning solvent P-D-680 Is toxic

and flammable.

Wear protective

goggles and gloves and use only in a

well ventilated area. Avoid contact

with skin, eyes, and clothes, and

don't breathe vapors. DO NOT use

near open flame or excessive heat.

The flash point Is 100-138 F (38-

59 C). If you become dizzy while

using cleaning solvent, get fresh air

immediately and medical aid.

contact with eyes Is made, wash your

eyes with water and get medical aid

Immediately.

(2) Clean metal parts in dry cleaning solvent.

20-7