BLOWER REPAIR (cont.) -726030150

TM 9-2320-360-34-2

CAUTION

Screws should be threaded all the

way into tapped holes of end plate.

Failure to comply may result in

damage to end plate.

NOTE

Six puller screws must be 1/4 in.-20 x

1-1/4 in. (32 mm) or longer.

(18) Install six screws (35) and align two puller tools

(26) on rear end plate (5).

(19) Turn both puller tools (26) evenly and remove

rear end plate (5) from blower (8).

(20) Remove puller tools from rear end plate (5).

(21) Remove 10 screws (36), lockwashers (37), and

washers (38) from front end cover (39). Discard

(22) Remove front end cover (39) and gasket (40)

from front end plate (41). Discard gasket.

(23) Bend tangs of key washer (42) flat.

(24) Remove screw (43), key washer (42), fuel pump

disk (44), and coupling spacer (45) from rotor

(30). Discard lockwasher.

20-5