BLOWER REPAIR (cont.) -726030149

TM 9-2320-360-34-2

20-2. BLOWER REPAIR (CONT)

NOTE

Five 5/ 16 in.-24 x 1-1/2 in. (38

mm) screws can be used to align

tapped holes in gears on rear end

plate.

Matchmarks on rotor and timing

gear must be aligned for proper

operation.

(11) Install puller tool (26) on left timing gear (23)

with two screws (27).

(12) Install puller tool (26) on right timing gear (17)

with three screws (27).

CAUTION

Puller screws must be tightened

evenly during removal of timing

gears. Failure to comply may result

in damage to gears.

(13) Tighten two screws (28) evenly and remove

gears (17 and 23) from rotors (29 and 30).

(14) Remove screws (27) and puller tools (26) from

gears (17 and 23).

NOTE

Spacers should be tagged

and

marked before removal.

(15) Remove two spacers (31) from two rotors (29

and 30).

(16) Remove six screws (32) and two flat bearing

retainers (33) from rear end plate (5).

(17) Remove two screws (34) from rear end plate (5).

20-4