CRANKSHAFT COVER, FRONT OIL SEAL, AND OIL PUMP REPAIR (Cont.) -726030137

TM 9-2320-360-34-2

19-14. CRANKSHAFT COVER, FRONT OIL SEAL, AND OIL PUMP REPAIR (CONT)

(11) Remove two nuts (24), screws (25), four

washers (26), strainer (27), cover (28),

and gasket (29) from oil inlet pipe

assembly (30). Discard gasket

(12) Remove two spacers (31) from screen

(27).

(13) Remove two locknuts (32), screws (33),

six washers (34), and two brackets (35)

from bracket (36). Discard locknuts.

(14) Remove two screws (37), lockwashers

(38), washers (39), and bracket (36) from

cylinder block (40). Discard lockwashers.

b. Disassembly

NOTE

Oil pump is inside crankshaft cover.

(1) Remove eight

screws

(1)

and

gear

retaining plate

(2) from rear of crankshaft cover (3). Discard

screws.

NOTE

Shaft is removed only if it fails

inspection.

(2) Remove drive gear (4) and driven gear (5)

from rear of crankshaft cover (3).

(3) Remove shaft (6) from crankshaft cover

(3).

(4) Support outer face of crankshaft cover (3)

on two wooden blocks.

(5) Remove front seal (7) from front side of

crankshaft cover (3). Discard seal.

19-122