FLYWHEEL HOUSING REPAIR (cont.) -726030096

TM 9-2320-360-34-2

(34) Coat new gasket (43) with grease.

(35) Install new gasket (43), access cover (44),

new copper washer (45), and screw (46)

on flywheel housing (2). Do not tighten.

(36) Install five screws (47) on access cover

(44). Do not tighten.

(37) Tighten six screws (46 and 47) to 25-30

lb-ft (35-41 Nm).

(38) Tighten two screws (18) to 25-30 lb-ft (35-

41 Nm).

f. Follow -On Maintenance

(1) Install flexplate assembly (para 3-17).

(2) Install oil pan (para 3-20).

(3) Install blower accessory drive hub (para 4-9).

(4) Install 12-volt (rear) alternator/bracket (TM 9-2320-360-20).

(5) Install DDEC oil pressure sensor (TM 9-2320-360-20).

(6) Remove engine from engine stand (para 19-3).

(7) Install air box covers (para 3-8).

(8) Install air box drains (para 3-9).

(9) Install exhaust manifolds (para 3-23).

(10) Install 24-volt (front) alternator/bracket (TM 9-2320-360-20).

(11) Install 150 amp circuit breakers (TM 9-2320-360-20).

(12) Install starter (TM 9-2320-360-20).

(13) Install sending units and attachments (TM 9-2320-360-20).

19-81