REAR END PLATE REPAIR (CONT) -726030047

TM 9-2320-360-34-2

19-6. REAR END PLATE REPAIR (CONT)

a. Removal

NOTE

Note position of special washer

before removing from rear end

plate.

(1) Remove screw (1), special washer (2), and

dummy hub (3) from rear end plate (4).

(2) Remove screw (5) and lockwasher (6) from

rear-end Slate (4). Discard lockwasher.

(3) Remove four screws (7), end plate (4) and

gasket (8) from engine block (9). Discard

gasket.

b. Disassembly

CAUTION

Support rear end plate on flat even

surface when removing screw

inserts to prevent warping or

bending of end plate.

NOTE

Do steps (1) and (2) only if screw

inserts are stripped.

(1) Remove two screw inserts (1) from rear end

plate (2).

(2) Remove eight screw inserts (3) from rear end

plate (2).

c. Assembly

CAUTION

Support rear end plate on flat even

surface when installing screw

inserts to prevent warping or

bending end plate.

NOTE

Do steps (1) and (2) only if screw

inserts were removed.

(1) Press eight screw inserts (1) into back of rear

end plate (2).

(2) Press two screw inserts (3) into front of rear

end plate (2).

19-32