|
| |
TM 9-2320-360-34-1
NOTE
Table 2-8 shows which injector is associated with each of the SIDS.
Table 2-8. Injector Identification
FIRING
SIDS
ORDER
CYLINDER
S001
1
3Right
S002
2
3Left
S003
3
4Right
S004
4
4Left
S005
5
2Right
S006
6
2Left
S007
7
1 Right
S008
8
1 Left
NOTE
If response time(s) is not 0.80 the following may be
causing intermittent failures:
a. sticky valve
b. air in fuel
c. low battery charge
d. broken spring or armature on the injector
e. problems in the charging system (loose
alternator belt, bad grounds, etc.)
f. signs of insulation wear on injector
harness
(1) Start and warm engine to operating temperature (at least 86F).
(2) Plug in DDR and select INJ RESP TIMES.
NOTE
Table 2-8 gives the firing sequence in relation to the
SID received.
(3) Read DDR display of injector response time (in firing order)
through several cycles. Note response time(s) of cylinder by
number in fault code.
Check which SIDS are displayed by DDR.
Change 3 2-62.1
|
