|
| |
TM 9-2320-360-34-1
11-6. AIR COMPRESSOR REPLACEMENT
This task covers:
a. Removal
c. Installation
b. Cleaning/Inspection
d. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Tools and Special Tools (Cont)
Cooling system drained (TM 9-2320-360-20).
Wrench Set, Socket, 3/8 In. Drive
Steering reservoir drained
(Item 232, Appendix E)
(LO 9-2320-360-12).
Wrench, Torque, Click-Type, 15-100 Lb-Ft
Air system drained (TM 9-2320-360-10).
(Item 238, Appendix E)
Batteries disconnected (TM 9-2320-360-20).
Wrench, Torque, 0-300 Lb-in. (Item 235,
Top doghouse insulation removed
Appendix E)
(TM 9-2320-360-20).
Wrench, Torque, 0-175 Lb-Ft (Item 236,
Front engine access panel removed
Appendix E)
(TM 9-2320-360-20).
Lower engine access panel removed
Materials/Parts
(TM 9-2320-360-20).
Adhesive-Sealant (Item 6, Appendix B)
Inner fender removed (left side only)
Compound, Sealing, Pipe Thread (Item 28,
TM 9-2320-360-20).
Appendix B)
Compound, Sealing (Item 22.1, Appendix B)
Tools and Special Tools
Grease, Automotive and Artillery (GAA)
Tool Kit, Genl Mech (Item 202, Appendix E)
(Item 32, Appendix B)
Hoist, Hand Operated (Item 69, Appendix E)
Solvent, Dry Cleaning (Item 54, Appendix B)
Pan, Oil Drain (Item 102, Appendix E)
Tags, Identification (Item 56, Appendix B)
Screws, Guide (Figure C-4, Appendix C)
Ties, Cable, Plastic (Item 60, Appendix B)
Sling, Endless Strap (Item 161, Appendix E)
Gasket (Item 30, Appendix F)
Wrench, Combination, 1-1/2 In. (Item 214,
Locknuts (2) (Item 86, Appendix F)
Appendix E)
Locknut (Item 96, Appendix F)
Wrench, Open-End, 1-5/8 In. and
Lockwashers (3) (Item 119, Appendix F)
1-13/16 In. (Item 224, Appendix E)
Lockwashers (4) (Item 122, Appendix F)
Wrench, Open-End, 1-7/8 and 1-11/16 In.
Packings, Preformed (2) (Item 161,
(Item 225, Appendix E)
Appendix F)
Wrench Set, Socket, 3/4 In. Drive
(Item 231, Appendix E)
Personnel Required
Two
a.
Removal
(1)
Remove 19 screws (1) and 3 covers (2)
from electronic control box (ECB) (3).
11-24 Change 2
|
