|
| |
TM 9-2320-360-34-1
CAUTION
Use
jumper
wire
only
between
terminals
indicated.
Failure
to
comply may result in damage to
DDEC components or wiring.
CONTINUITY TEST
(1) Install a jumper wire between sockets A
and B of TRS harness connectors.
(2) Read resistance between sockets T1 and
T2 of engine harness connector.
CONTINUITY TEST
Read resistance of TRS across
sensor pins A and B.
Check connectors at SRS (both harness side
and SRS side) for damage; bent, corroded, and
unseated pins or sockets, or bad contacts.
2-37
|
