|
| |
TM 9-2320-360-34-1
CONTINUITY TEST
(1) Turn ENGINE switch OFF.
(2) Disconnect engine harness connector at ECM.
(3) Read resistance between sockets S1 and S2 of
engine harness connector.
CONTINUITY TEST
(1) Remove ECM (TM 9-2320-360-20).
(2) Disconnect SRS connector.
(3) Read resistance between sockets S1 and S2 on
engine harness connector.
(4) Read resistance between sockets S1 and
ground, then between S2 and ground.
CAUTION
Use jumper wire only between terminals
indicated. Failure to comply may result in
damage to DDEC components or wiring.
CONTINUITY TEST
(1) Remove ECM (TM 9-2320-360-20).
(2) Disconnect SRS connector and install a
jumper wire between sockets A and B of SRS
harness connector.
(3) Read resistance between sockets S1 and S2
on engine harness connector.
2-31
|
