|
| |
TM 9-2320-360-34-1
3-28. ENGINE TESTING
This task covers:
a. Compression Check
b. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Materials/Parts
Air cleaner assembly removed
Rags (Item 51, Appendix B)
(TM 9-2320-360-20).
Tie, Cable, Plastic (Item 60, Appendix B)
Exhaust pipe removed (TM 9-2320-360-20).
Clamps (2) (Item 7, Appendix F)
Fuel Pipe, Jumper (Item 13, Appendix F)
Tools and Special Tools
Gasket (Item 29, Appendix F)
Tool Kit, Genl Mech (Item 202, Appendix E)
Locknuts (2) (Item 81, Appendix F)
Gage Set, Cylinder Compression (Item 54,
Locknut (Item 96, Appendix F)
Appendix E)
Lockwashers (2) (Item 120, Appendix F)
Wrench, Fuel Line Nut (Item 222, Appendix E)
Rings, Seal (34) (Item 272, Appendix F)
Wrench Set, Socket, 3/8 In. Drive (Item 232,
Appendix E)
Personnel Required
Wrench, Torque, 0-175 Lb-Ft (Item 236,
Two
Appendix E)
Wrench, Torque, 0-300 Lb-In. (Item 235,
Appendix E)
NOTE
Engine temperature should remain between 180-200° F (93-97° C) during engine
testing procedure.
a.
Compression Check
(1)
Start
engine
and
run
until
normal
operating
temperature
is
reached
(TM 9-2320-360-10).
(2)
Stop engine (TM 9-2320-360-10).
3-139
|
