|
| |
TM 9-2320-360-34-1
3-10. CYLINDER HEAD REPLACEMENT (CONT)
c.
Installation
CAUTION
· Never install used compression gaskets. Installing used gaskets may cause
compression leaks.
· Seal strip has one colored edge to prevent it from being installed improperly. It
must be installed with color facing out away from pistons all the way around
groove. Failure to comply may result in oil leaks.
NOTE
If compression gaskets are color coded, color codes should be same for all
compression gaskets.
(1)
Install 4 new compression gaskets (1) and new seal strip gasket (4) on engine block (5).
WARNING
Adhesive-sealant can burn easily, can give off harmful vapors, and is harmful to
skin and clothing. To avoid injury or death, keep away from open fire and use in
well-ventilated area. If adhesive-sealant gets on skin or clothing, wash
immediately with soap and water.
CAUTION
Water seals can move out of position during cylinder head installation. To prevent
this, a spray adhesive can be used to hold seals in place. Do not apply adhesive
directly to seals. Wipe off any adhesive that gets on fire deck or liner bores.
Failure to comply may result in damage to equipment.
(1.1)
Spray a light, uniform coating of spray adhesive into the water seal counterbores (2).
NOTE
Allow the adhesive to dry to a high-
tack
consistency
(sticky)
before
installing seals.
(1.2)
Install 16 new water seals (2.1) and new
oil seal (3) on engine block (5).
(2)
Remove paper covering from back of two
support shims (6) and install glued side
down.
3-78 Change 1
|
