|
| |
TM 9-2320-360-34-1
3-7. DDEC II SYNCHRONOUS REFERENCE SENSOR (SRS) AND TIMING
REFERENCE SENSOR (TRS) REPLACEMENT/ADJUSTMENT
This task covers:
a. Removal
c. Adjustment
b. Installation
d. Follow-On Maintenance
Initial Setup:
Equipment Conditions
Tools and Special Tools (Cont)
ECM removed (TM 9-2320-360-20).
Timing Tool, Crank Position (Item 197,
No. 1 right fuel injector removed (para 4-2).
Appendix E)
Wrench Set, Socket, 3/4 In. Drive (Item 231,
Tools and Special Tools
Appendix E)
Tool Kit, Genl Mech (Item 202, Appendix E)
Wrench Set, Socket, 3/8 In. Drive (Item 232,
Alignment Tool, SRS/TRS (Item 196, Appendix E)
Appendix E)
Socket, Sockethead Screw, 3/16 In. (Item 172,
Wrench, Torque, 0-300 Lb-In. (Item 235,
Appendix E)
Appendix E)
a.
Removal
(1)
Disconnect
two
connectors
(1)
from
synchronous reference sensor and timing
reference sensor (SRS/TRS) (2).
(2)
Remove two sockethead screws (3) and
bracket (4) from front end plate (5).
(3)
Remove screw (6) and retaining clip (7)
from bracket (4).
(4)
Remove SRS/TRS (2) from bracket (4).
Change 3 3-61
|
