|
| |
TM 9-2320-360-34-1
WARNING
Wear approved eye protection when performing
transmission pressure checks. Failure to
comply may result in oil getting Into eyes. If oil
contacts
eyes,
seek
medical
attention
immediately.
NOTE
This fault will only occur if the control valve is
faulty or if the governor pressure is too high.
Therefore the governor oil filter screen cannot be
at fault in this case.
REAR GOVERNOR PRESSURE TEST
(1) Remove plug from rear governor test port.
(2) Install 0-160 psi (0-1103 kPa) pressure gage on rear
governor test port.
(3) Start engine (TM 9-2320-360-10).
(4) Position transmission range selector to 2-5 position.
(5) Release parking brake (TM 9-2320-360-10) and drive
vehicle.
(6) Check reading on pressure gage when rpm reaches
1650, in 5th gear at approximately 35 mph, with aid of
assistant.
(7) Shut off engine (TM 9-2320-360-10).
(8) Remove pressure gage from rear governor test port.
(9) Install plug on rear governor test port.
Change 2 2-113 (2-114 and 2-115 blank)
|
