|
| |
TM 9-2320-360-34-1
(1)
Fabricate from 1/4 in. (6 mm) thick, 1/2 in. (13 mm) wide, mild steel stock.
(2)
Using hacksaw, cut steel stock to 14 1/2 in. (36.8 cm).
(3)
Using machinist's vise, bend steel stock 900 where indicated.
(4)
Drill .344 in. (8.73 mm) hole where indicated.
(5)
Using file or grinder, remove any sharp edges.
(6)
All dimensions are in inches (millimeters).
Figure C-16. Differential Carrier Preload Gage.
C-10 Change 2
|
