|
| |
TM 9-2320-360-34-1
17-3. WINCH PLATFORM REPLACEMENT
This task covers:
a. Removal
c. Follow-On Maintenance
b. Installation
INITIAL SETUP
Equipment Conditions
Tools and Special Tools
Air system drained (TM 9-2320-360-10).
Tool Kit, Genl Mech (Item 202, Appendix E)
Battery box pulled out (TM 9-2320-360-10).
Jackstands (4) (Item 93, Appendix E)
Exhaust heat shield removed
Sling Assembly (Item 160, Appendix E)
(TM 9-2320-360-20).
Socket Set, Deep Well, 12 Point, 1/2 In. Drive
Left rear fender removed (TM 9-2320-360-20).
(Item 167, Appendix E)
Right rear fender removed
Wrench, Impact, Electric, 1 In. (Item 223,
(TM 9-2320-360-20).
Appendix E)
Tail pipe assembly support removed
Wrench Set, Socket, 3/4 In. Drive (Item 231,
(TM 9-2320-360-20).
Appendix E)
Clearance lights removed (TM 9-2320-360-20).
Wrench, Torque, 0-175 Lb-Ft (Item 236,
Reflectors removed (TM 9-2320-360-20).
Appendix E)
Winch ladder removed (TM 9-2320-360-20).
Wrench, Torque, 0-600 Lb-Ft (Item 233,
Catwalk removed (TM 9-2320-360-20).
Appendix E)
Winch return hose removed
(TM 9-2320-360-20).
Materials/Parts
Winch return manifold removed
Adhesive-Sealant (Item 6, Appendix B)
(TM 9-2320-360-20).
Rope, 50 Ft (Item 53, Appendix B)
Auxiliary winch removed (TM 9-2320-360-20).
Ties, Cable, Plastic (Item 60, Appendix B)
Hydraulic reservoir removed
Locknuts (56) (Item 88, Appendix F)
(TM 9-2320-360-20).
Locknuts (4) (Item 86, Appendix F)
Arctic kit battery box removed (if equipped)
Locknuts (4) (Item 96, Appendix F)
(TM 9-2320-360-20).
Hydraulic pump removed (para 17-11).
Personnel Required
Winches removed (para 17-2).
Three
Control console removed (para 17-7).
Decontamination unit removed
(TM 9-2320-360-20).
a.
Removal
(1)
Remove two locknuts (1), screws (2), and
pogo stick assembly (3) from platform (4)
while
assistant
supports
pogo
stick.
Discard locknuts.
(2)
Lay pogo stick assembly (3) across fifth
wheel (5).
Change 1 17-7
|
