|
| |
TM 9-2320-360-34-1
15-2. FRONT SPRING REPAIR (CONT)
NOTE
Slotted end of pin must align with
spring lockpin hole when installed.
(16)
Position spring (2) on spring link (4) with pin (20)
with aid of assistant.
CAUTION
Do not allow spring lockpin to enter
slot at an angle. It will wedge and
gall when locked at an angle. It will
become loose and allow pin to turn
and wear hanger bracket resulting in
failure of pin, spring bushing or
bracket.
(17) Position spring lockpin (21) in spring link (4) and
pin (20) until spring lockpin taper aligns with
locking slot.
(18) Tap spring lockpin (21) to lock pin (20) in spring
link (4).
(19) Install new lockwasher (22) and nut (23) on
spring lockpin (21). Torque to 55 lb-ft (75 Nm).
(20) Remove floor jack (11) from under center of
spring (2).
(21) Position floor jack (11) under axle differential
(24).
(22) Raise axle (12) with floor jack (11).
(23) Remove jackstand (25) from axle (12).
15-8
|
