|
| |
TM 9-2320-360-34-1
WARNING
Spring weighs 192 lb (87 kg). Keep
out from underneath spring when
removing. Failure to comply may
result In Injury to personnel.
(8)
Position spring (2) on floor jack (11).
(9)
Position spring (2) under front axle (12).
(10)
Coat inside of bushings (1) and spring pin hole
(13) in front bracket (14) with lubricating oil.
(11)
Raise floor jack (11) and spring (2) until spring
pin hole (15) aligns with front bracket (14) with
aid of assistant.
NOTE
Slotted end of pin must align with
spring lockpin hole when installed.
(12) Position spring (2) on front bracket (14) with pin
(16).
CAUTION
Do not allow spring lockpin to enter
slot at an angle. It will wedge and
gall when locked at an angle. It will
become loose and allow pin to turn
and wear hanger bracket resulting in
failure of pin, spring bushing or
bracket.
NOTE
Spring lockpin hole on bracket is
only machined on one side.
Spring lockpin key must be installed
on nonmachined side, lockwasher
and nut must be on machined side.
(13) Position spring lockpin (17) in front bracket (14)
and pin (16) until spring lockpin taper aligns with
locking slot.
(14) Tap spring lockpin (17) to lock pin (16) in front
bracket (14).
(15) Install new lockwasher (18) and nut (19) on
spring lockpin (17). Torque to 55 lb-ft (75 Nm).
15-7
|
