|
| |
TM 9-2320-356-BD
Option 2:
Long Wire Antenna.
1.
Strip approximately 2 inches of insulation from one end of the wire.
2.
Attach the bare lead to the center of the antenna connection on the receiver by
jamming it into the hole.
3.
Tape or tie wire to the antenna connector to prevent it from being pulled or
vibrated out of the hole.
4.
Stretch out wire and tie an improvised insulator to the opposite end. Place a
rope or wire on the opposite side of the insulator and tie off the slack to tree or
pole to create as near vertical an antenna as possible.
5.
Record BDAR action taken.
When the mission is complete, as soon as
practicable,
repair using standard maintenance procedures.
15-5
|
