|
| |
TM 9-2320-356-BD
3.
Lay the stripped ends side by side.
4.
Twist the wire ends together.
5.
Use rosin-core solder and solder wires together.
6. Slide sleeve or tubing over the soldered wires, or apply tape to insulate the
conductor.
7.
Record the BDAR action taken. When the mission is completed, as soon as
practicable, repair using standard maintenance procedures.
Option 2:
Wire Splice.
1.
If terminal lug barrel is used for splicing, select barrel diameter large
enough to accept both wires.
2.
Cut off terminal flush with pre-insulation.
3.
Cut insulating sleeve 1 inch longer than the barrel.
4.
S t r ip
5.
Slide
wire.
8-12
broken ends of wires.
insulating sleeve or shrink tubing,
if available, over one end of broken
|
