 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-312-24-2
Truck Engine
Disassembly and Assembly Section
i01748118
i01761781
Belt Tightener - Disassemble
Belt Tightener - Assemble
SMCS Code: 1358-015
SMCS Code: 1358-016
Disassembly Procedure
Assembly Procedure
Table 49
Table 50
Required Tools
Required Tools
Part
Tool
Part Number
Part Description
Qty
Tool
Part Description
Qty
Number
1P-1855
1
A
Retaining Ring
1P-1855
A
1
Retaining Ring Pliers
Pliers
1
1P-0510
1P-0510
B
Driver Group
1
B
Driver Gp
Start By:
a. Remove the water pump belt tightener. Refer to
Disassembly and Assembly, "Belt Tightener -
Remove".
g00619412
Illustration 267
1. Check the condition of shaft (4) in idler plate
assembly (5). Replace idler plate assembly (5) if
shaft (4) is worn.
g00619391
Illustration 265
1. Use Tooling (A) to remove retaining ring (1).
Remove pulley (2) from the idler plate assembly.
g00619393
Illustration 268
2. Thoroughly clean the following components: the
bearing bore in the pulley, the outside bearing
bore of the pulley, and the outside diameter of
g00619393
two bearings (3). Apply 9S-3263 Thread Lock
Illustration 266
Compound in the bearing bore of the pulley and
on the outside diameter of two bearings (3).
Install two bearings (3) in the pulley with Tooling
press and Tooling (B).
(B). Ensure that bearings (3) are centered in the
pulley.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals