Inlet Air Temperature Sensor - Remove and Install

TM 9-2320-312-24-2

Truck Engine

Disassembly and Assembly Section

NOTICE

Care must be taken to ensure that fluids are contained

during performance of inspection, maintenance, test-

ing, adjusting and repair of the product. Be prepared to

collect the fluid with suitable containers before open-

ing any compartment or disassembling any compo-

nent containing fluids.

Refer to Special Publication, NENG2500, "Caterpillar

Tools and Shop Products Guide" for tools and supplies

suitable to collect and contain fluids on Caterpillar

products.

Dispose of all fluids according to local regulations and

mandates.

g00771041

Illustration 253

(1) Boost pressure sensor

(2) Electrical connection for boost pressure sensor

1. Install boost pressure sensor (1). Tighten the

boost pressure sensor to a torque of 10 2 Nm

(90 18 lb in).

2. Connect plug (2) for boost pressure sensor (1).

g00771192

Illustration 254

i01481365

Typical example

Inlet Air Temperature Sensor -

(1) Inlet air temperature sensor

(2) Electrical connection for inlet air temperature sensor

Remove and Install

1. Disconnect plug (2) for inlet air temperature

SMCS Code: 1921-010

sensor (1).

Removal Procedure

2. Remove inlet air temperature sensor (1).

Installation Procedure

NOTICE

Keep all parts clean from contaminants.

NOTICE

Contaminants may cause rapid wear and shortened

Keep all parts clean from contaminants.

component life.

Contaminants may cause rapid wear and shortened

component life.