Water Pump - Assemble

TM 9-2320-312-24-2

Truck Engine

Disassembly and Assembly Section

g00614253

g00614283

Illustration 114

Illustration 116

5. Remove seal (5) from the water pump housing

1. Install the shaft and the bearing into pulley (3)

with the handle from Tooling (B) and a press.

with a press. Install the shaft until the shaft is

flush with the end of pulley (3).

2. Press the shaft, the bearing, and pulley (3) as a

unit into the water pump housing. The distance

between the front of pulley (3) and the machined

surface of the water pump housing must be

103.8 0.3 mm (4.09 0.01 inch).

Note: For information on the reusability of pulley

(3), refer to Guideline For Reusable Parts And

Salvage Operations, SEBF8046, "Cast Iron and

Steel Pulleys".

g00614261

Illustration 115

6. Remove the shaft and the bearing from pulley

(3) with a press.

i01275986

Water Pump - Assemble

SMCS Code: 1361-016

Assembly Procedure

g00614294

Illustration 117

Table 22

3. Install seal (5) in the water pump housing with

Tool (A).

Required Tools

Part

Tool

Part Description

Qty

Number

5P-9722

Seal Driver

NOTICE

Keep all parts clean from contaminants.

Contaminants may cause rapid wear and shortened

component life.