|
|
24
TM 9-2320-312-24-2
Truck Engine
Disassembly and Assembly Section
i01334762
Turbocharger - Install
SMCS Code: 1052-012
Installation Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
1. Inspect the turbocharger gasket for wear or
damage. If the turbocharger gasket is worn or
damaged, use a new part for replacement.
2. Apply 5P-3931 Anti-Seize Compound on
the threads of the mounting studs for the
turbocharger.
g00617515
Illustration 55
5. Inspect the gaskets for oil supply tube assembly
(5) and tube assembly (2). If the gaskets are worn
or damaged, use a new part for replacement.
6. Position tube assembly (2) and the gasket
on turbocharger (6). Install bolts (1) on the
turbocharger and install bolts (3) on the cylinder
block.
7. Install the gasket for oil supply tube assembly
(5) and connect oil supply tube assembly (5) to
turbocharger (6).
g00617565
Illustration 54
i01679487
Exhaust Manifold - Remove
3. Position the turbocharger gasket and
and Install
turbocharger (6) on the exhaust manifold. Install
nuts (4) that fasten turbocharger (6) to the
exhaust manifold.
SMCS Code: 1059-010
4. Tighten the locknuts that fasten the turbocharger
Removal Procedure
to the exhaust manifold.
Start By:
Tighten the 3E-8017 Locknut with the Spiralock
thread to the following torque: .......... 54 5 Nm
a. Remove the turbocharger. Refer to Disassembly
(40 4 lb ft)
and Assembly, "Turbocharger - Remove".
Tighten the standard 9X-6620 Locknut to the
following torque: .......... 70 5 Nm (50 4 lb ft)
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |