|
|
TM 9-2320-312-24-2
Truck Engine
Disassembly and Assembly Section
6. Remove O-ring seal (6) from the elbow. Inspect
2. Cut nylon strap (2) that fastens the wiring
O-ring seal (6) for wear or damage. If the O-ring
harness to the unit injector hydraulic pump.
seal is worn or damaged, use a new part for
replacement.
i01153818
Fuel Transfer Pump - Install
SMCS Code: 1256-012
Installation Procedure
NOTICE
Keep all parts clean from contaminants.
g00612496
Illustration 6
Contaminants may cause rapid wear and shortened
component life.
3. Remove the bolts, clip (4) and fuel transfer pump
(3) from the unit injector hydraulic pump.
g00612518
Illustration 9
g00612507
Illustration 7
1. Clean all components and the mating surfaces.
Inspect all components. If any component is worn
4. Remove O-ring seal (5) from the unit injector
or damaged, use a new part for replacement.
hydraulic pump. Inspect O-ring seal (5) for
Install the elbows for the fuel inlet port and the
wear or damage. If the O-ring seal is worn or
fuel outlet port on the fuel transfer pump.
damaged, use a new part for replacement.
2. Install the O-ring seal (6).
g00612518
Illustration 8
g00612507
Illustration 10
5. Remove the elbows for the fuel inlet port and the
fuel outlet port from the fuel transfer pump.
3. Install O-ring seal (5) on the unit injector
hydraulic pump.
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |