0224-14 Engine Cranking with Theft Deterrent Active (00)

134

TM 9-2320-312-24-2

Troubleshooting Section

The parameter "Powertrain Data Link" must be

i01641127

programmed to J1939.

0224-14 Engine Cranking with

Theft Deterrent Active (00)

The ECM is unsuccessful in receiving a specific

message from a device.

SMCS Code: 1900; 1901

Conditions Which Generate This Code:

The device is broadcasting a fault code.

The diagnostic code indicates that an attempt is

being made in order to start the engine. However,

the theft deterrent feature is enabled. This prevents

The device is broadcasting a code that is not

the engine from being started.

supported.

Note: This diagnostic code represents an event. This

System Response:

diagnostic code does not represent an electronic

system fault.

Electronic System Response J1939

communications to the engine and from the

System Response:

engine are terminated for the specific message

while this code is active. The functionality of some

Electronic System Response The diagnostic code

features may be affected while this code is active.

is active only. The diagnostic code will be active

Traction control or transmission controls may be

when the theft deterrent feature is enabled and the

disabled.

engine is cranking for more than 5 seconds.

Service Tool Display or Lamps The Caterpillar

Service Tool Display and Lamps Caterpillar

Electronic Technician (ET) will indicate a safe default

Electronic Technician (ET) will not display a status.

value or display "DIAG" on a status screen. If the

The Check Engine Lamp will be illuminated.

device sends a message that is not supported, the

service tool will display "J1939 No Support". ET

Engine Response The engine will not start until the

will display a list of the devices that are causing

correct password is entered.

this code on the "Active Faults" screen. If the list of

devices that are causing this code is too large, all

Troubleshooting:

of the devices will not be listed until some of the

incorrect messages are corrected.

The diagnostic code indicates that an attempt is

being made in order to start the engine. However,

Perform the following diagnostic procedure:

the theft deterrent feature is enabled. This diagnostic

"Powertrain Data Link Circuit - Test"

code does not represent an electronic system fault.

Results:

There are no problems that require troubleshooting.

OK STOP.

Results:

OK STOP.

i01617519

0231-11 J1939 Data Link Fault

i01815528

(58)

0231-02 J1939 Required Data

Not Received (58)

SMCS Code: 1408-038; 1901-038

Conditions Which Generate This Code:

SMCS Code: 1901-038

This condition indicates that the SAE J1939 data

Conditions Which Generate This Code:

link is not communicating correctly. The parameter

"Powertrain Data Link" must be programmed to

This condition indicates that the J1939 data link is

J1939.

receiving information from a specified device but

the information is incomplete or corrupted. All of the

following conditions must be met: