 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-312-24-2
Troubleshooting Section
Table 61
Table 65
Manufacturer
Alternative
Default
Alternatives
Default
GM
N/A
N/A
"Not Installed"
"Installed"
Other
"4-pin connector"
"NO"
"Primary Fuel Tank Size"
OCT01 and newer Personality Modules.
Note: This feature is only available when "Truck
Manufacturer" is programmed to "GMT-560".
Table 62
Manufacturer
OCT01 and newer Personality Modules.
Alternative
Default
or Model
This parameter is used to identify the size of the
GM 530/540
"4-pin"
"NO"
primary fuel tank in gallons.
"2-pin
GMT-560
"NO"
switch"
Table 66
Other
"2-wire float sensor"
"NO"
Alternatives
Default
"None"
"50 gallons"
"Engine Oil Pressure Sensor"
"25 gallons"
"35 gallons"
JUN98 and newer Personality Module.
"Secondary Fuel Tank Size"
An optional engine oil pressure sensor is sometimes
installed on applications with an instrument cluster
Note: This feature is only available when "Truck
that requires an engine oil pressure gauge. The
Manufacturer" is programmed to "GMT-560".
3126B engine and the 3126E engine does not
require an engine oil pressure indicator for engine
OCT01 and newer Personality Modules.
protection. The HEUI fuel system will not allow the
engine to run if no engine oil pressure is present.
This parameter is used to identify the size of the
secondary fuel tank in gallons.
If the engine oil pressure sensor is installed in the
engine, the "Engine Oil Pressure Sensor" parameter
Table 67
must be set to "Installed". The engine oil pressure
Alternatives
Default
signal will be communicated over the ATA Data link.
"25 gallons"
"None"
Table 63
"35 gallons"
"50 gallons"
Alternatives
Default
"Not Installed"
"Installed"
i01727019
OCT01 and newer Personality Modules.
Idle Parameters
Table 64
SMCS Code: 1901
Manufacturer
Alternatives
Default
or Model
"Idle Vehicle Speed Limit"
"Not Installed"
GM 530/540
"Installed"
The "Idle Vehicle Speed Limit" is the maximum
"Not Installed"
GMT-560
"Installed"
vehicle speed for setting or maintaining a set
"Not Installed"
Other
"Installed"
engine rpm in the idle mode. In order to enter the
idle mode, the engine rpm must be set by the
set/resume switch while the cruise control on/off
"Oil Level Switch Installation Status"
switch is in the ON position. If the vehicle speed
signal exceeds this value, the engine will not
Note: This feature is only available when "Truck
maintain the set engine rpm.
Manufacturer" is programmed to "GMT-560".
Table 68
OCT01 and newer Personality Modules.
Minimum
Maximum
Default
This parameter is used to tell the ECM that an oil
2 km/h (1 mph)
24 km/h (15 mph)
2 km/h (1 mph)
level sensor is installed.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals