 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-312-24-1
FIFTH WHEEL HYDRAULIC LIFT CYLINDER REPLACEMENT - CONTINUED
0158 00
INSTALLATION - CONTINUED
NOTE
Ensure spacer (15) is in position on pivot bar.
Apply grease to bushing surface of base prior to installation.
3.
Working from left side of vehicle (to install right cylinder), use a block of wood and hammer to drive pivot bar (16)
inward while positioning cylinder base (12) in line with travel of bar. Continue to drive pivot bar through base and pivot
bar tube (17) until fully installed.
4.
Install spacer (14) and bolt (13) on each side of frame.
14
13
15
16
12
17
5.
Install dual wheels (TM 9-2320-312-10).
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may result in injury or death to
personnel.
6.
Attach a sling to cylinder (3) and attach sling to overhead lifting device. Raise overhead lifting device to take up slack in
sling and support cylinder.
7.
Position cylinder (3) at vehicle. Ensure cylinder is oriented with fittings facing toward front of vehicle.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals