PLACING CAB IN 90-DEGREE TILT POSITION - CONTINUED

TM 9-2320-312-24-1

PLACING CAB IN 90-DEGREE TILT POSITION - CONTINUED

0147 00

PLACING CAB IN 90-DEGREE TILT POSITION - CONTINUED

WARNING

All personnel must stand clear of front of cab when safety prop is disconnected. As long as safety prop

remains disconnected, stay clear of front of cab. Failure to follow this warning could result in injury or

death to personnel.

DO NOT place body under cab when cab is supported only by overhead lift.

Ensure cab's forward tilting movement is controlled at all times by overhead lift's braking capability.

Proceed slowly and with great caution. Failure to follow this warning could cause loss of control of cab,

resulting in injury or death to personnel and damage to cab.

Watch chain that is rigged between rear of cab and rear of tractor. Ensure it does not become tangled or

caught up on any component as cab is tilted. If chain becomes hung up, it could damage component or

injure personnel if chain breaks free suddenly.

21.

Begin to lift and tilt cab with overhead lift.

NOTE

As cab reaches 90-degree tilt position, chain that is rigged between rear of cab and rear of tractor will tighten.

22.

Continue to slowly lift and tilt cab with overhead lift. Alternate between lifting cab and moving overhead lift forward as

cab's center of gravity shifts toward balance point.

23.

When cab reaches balance point, slowly lower cab until 90-degree tilt is reached. Front surface of cab will be resting on

front bumper cribbing, and supported by chain rigged to rear of tractor.

0147 00-9