 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-312-24-1
REAR AXLE ASSEMBLY REPLACEMENT - CONTINUED
0145 00
INSTALLATION - CONTINUED
NOTE
Lug nuts cannot be fully tightened until vehicle is lowered to the ground.
9.
Install rear dual wheels (TM 9-2320-312-10).
10.
Raise floor jack sufficiently to remove jackstands or cribbing from each side of frame (9). Lower vehicle to the ground.
11.
Fully and evenly tighten lug nuts on rear dual wheels to 500 lb-ft (678 Nm), according to tightening pattern shown.
WHEEL NUT TIGHTENING PATTERN
12.
Connect two air lines to each brake chamber (WP 0031 00).
13.
Connect drive shaft to rear axle differential (Group 120 Commercial Service Manuals).
14.
Check fluid level in rear axle differential and in wheel hub ends. Refer to Unit PMCS Introduction and Unit PMCS, WP
0008 00 and WP 0009 00, for appropriate lubricating oil, capacities, and procedures.
15.
Lower fifth wheel (TM 9-2320-312-10).
16.
Remove wheel blocks.
END OF WORK PACKAGE
0145 00-5/6 Blank
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals