 |
|||
|
|
|||
|
Page Title:
COOLING FAN AND FAN CLUTCH INSTALLATION |
|
||
| ||||||||||
|
|
 TM 9-2320-312-24-1
COOLING FAN AND FAN CLUTCH MAINTENANCE - CONTINUED
0141 00
COOLING FAN AND FAN CLUTCH INSTALLATION
1.
Install spacer (13) and fan clutch (6) to pulley (14) at front of engine with six socket head capscrews (15). Tighten cap-
screws to 45 lb-ft (61 Nm).
2.
Install fan (11) to studs (16) of fan clutch (6) with six washers (10), new lockwashers (9), and nuts (8). Tighten nuts
to 26 lb-ft (35 Nm).
3.
Apply antiseizing tape to fitting (17) and install fitting to cylinder (12).
4.
Install radiator (WP 0142 00).
5.
Check clearance between outer edge of fan and fan shroud. Clearance on RIGHT SIDE should be at least 1 in (25
mm). Clearance on top, bottom, and left side should be at least in (19 mm). Adjust position of fan shroud if nec-
essary.
CAUTION
Too much slack in air line at fan clutch may result in air line being cut by fan.
6.
Check tension in air line to cylinder (12) at front of fan clutch (6). Front-to-rear play should not be greater than in
(13 mm). Adjust tension of air line, if necessary, by loosening and tightening air line clamp at right side of fan
shroud.
AIR CYLINDER REMOVAL
1.
Drain air system (TM 9-2320-312-10).
2.
Remove radiator (WP 0142 00).
3.
Remove locknut (18) and tab washer (19) from cylinder (12). Discard locknut, tab washer, and cylinder.
4.
Remove cylinder (12) from fan clutch (6).
12
19
18
6
0141 00-5
Change 1
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals