 |
|||
|
|
|||
|
Page Title:
TRANSMISSION OIL SAMPLING VALVE HOSE AND FITTINGS REMOVAL - CONTINUED |
|
||
| ||||||||||
|
|
 TM 9-2320-312-24-1
ENGINE AND TRANSMISSION OIL SAMPLING VALVES, HOSES,
AND FITTINGS REPLACEMENT - CONTINUED
0132 00
TRANSMISSION OIL SAMPLING VALVE HOSE AND FITTINGS REMOVAL - CONTINUED
4.
Trace hose (18) to right-front corner of valve body (21) on underside of transmission. Remove tiedown straps and dis-
card.
5.
Disconnect hose (18) from reducer (19) and remove from vehicle.
6.
As required, remove reducer (19) and adapter (20) from valve body (21).
18
19
21
20
TRANSMISSION OIL SAMPLING VALVE HOSE AND FITTINGS INSTALLATION
NOTE
Route hose between points of installation as noted during removal. Ensure new tiedown straps are
installed to support hose after all connections are made.
Apply pipe sealing compound to male threads of fittings where use of pipe sealing compound was noted
during removal.
1.
If removed, install adapter (20) and reducer (19) to valve body (21).
2.
Position hose (18) between points of installation. Connect hose to reducer (19).
3.
If removed, install the following fittings:
a.
Install bulkhead fitting (6) to bracket (9) with starwasher (5) and nut (4).
b.
Install elbow (2) to bulkhead fitting (6).
c.
Install oil sampling valve (1) to elbow (2). Ensure discharge port (3) of valve is facing down.
d.
Install straight fitting (7) to bulkhead fitting (6).
4.
Connect hose (18) to straight fitting (7).
5.
Check transmission fluid level on dipstick. Add transmission fluid as required (TM 9-2320-312-10).
6.
Install transmission access cover (WP 0039 00).
END OF WORK PACKAGE
0132 00-7/8 Blank
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals