ENGINE OIL SAMPLING VALVE HOSES AND FITTINGS INSTALLATION - CONTINUED

TM 9-2320-312-24-1

ENGINE AND TRANSMISSION OIL SAMPLING VALVES, HOSES,

AND FITTINGS REPLACEMENT - CONTINUED

0132 00

ENGINE OIL SAMPLING VALVE HOSES AND FITTINGS INSTALLATION - CONTINUED

Lower cab (TM 9-2320-312-10).

10.

Check engine oil level on dipstick. Add engine lubricating oil as required (TM 9-2320-312-10).

11.

Install transmission access cover (WP 0039 00).

TRANSMISSION OIL SAMPLING VALVE HOSE AND FITTINGS REMOVAL

WARNING

When servicing this vehicle, performing maintenance, or disposing of materials such as engine coolant,

transmission fluid, lubricants, battery acids or batteries, consult your unit/local hazardous waste disposal

center or safety office for local regulatory guidance. If further information is needed, please contact The

Army Environmental Hotline at 1-800-872-3845.

NOTE

Use a drain pan to capture any residual oil in hose. Dispose of oil in accordance with local policy and

ordinances. Ensure all spills are cleaned up.

Note routing of hose to ensure correct installation.

Pipe sealing compound is used at certain fittings to ensure a leak-free seal. Note where pipe sealing

compound is used.

Remove transmission access cover (WP 0039 00).

Disconnect hose (18) from straight fitting (7) at oil sampling valve (1).

As required, remove the following fittings at oil sampling valve (1):

Remove straight fitting (7) from bulkhead fitting (6).

Remove oil sampling valve (1) from elbow (2).

Remove elbow (2) from bulkhead fitting (6).

Remove nut (4), starwasher (5), and bulkhead fitting (6) from bracket (9).

0132 00-6