 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-312-24-1
DRAINING AND FILLING HYDRAULIC RESERVOIR - CONTINUED
0129 00
FILLING
CAUTION
Wipe area clean around filler cap prior to removing cap. Contamination of hydraulic system could result in
equipment failure.
1.
Remove filler cap (3) from hydraulic reservoir (1).
WARNING
Avoid overfilling hydraulic reservoir. Expansion of hydraulic fluid during vehicle operation may cause
hydraulic fluid to overflow hydraulic reservoir, creating a slipping hazard. Failure to follow this warning
may cause injury to personnel and damage to equipment.
2.
Inspect screen at filler opening to ensure it is clean and free of debris. Add hydraulic fluid until sight gauge (4) shows
fluid at bottom of gauge. Install filler cap (3).
3.
Start engine (TM 9-2320-312-10). Cycle steering from left to right and return, making three complete cycles. Raise and
lower fifth wheel to circulate hydraulic fluid and allow fluid to warm up and expand.
4.
With fifth wheel fully lowered and steering centered, check fluid level on sight gauge (4). Level of hydraulic fluid
should be even with FULL line stenciled on side of hydraulic reservoir (1).
5.
If no hydraulic fluid shows on sight gauge, remove filler cap (3) and add hydraulic fluid until level of fluid is as speci-
fied in step 4 above. Reinstall filler cap.
3
1
4
END OF WORK PACKAGE
0129 00-3/4 Blank
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals