PUMP-TO-TILT CYLINDER HOSES REMOVAL

TM 9-2320-312-24-1

CAB TILT HYDRAULIC HOSES AND FITTINGS REPLACEMENT - CONTINUED

0126 00

PUMP-TO-TILT CYLINDER HOSES REMOVAL

WARNING

When servicing this vehicle, performing maintenance, or disposing of materials such as engine coolant,

transmission fluid, lubricants, battery acids or batteries, consult your unit/local hazardous waste disposal

center or safety office for local regulatory guidance. If further information is needed, please contact The

Army Environmental Hotline at 1-800-872-3845.

CAUTION

Wipe area clean around all hydraulic connections prior to disconnecting. Cap or plug all openings after dis-

connecting. Contamination of hydraulic system could result in equipment failure.

NOTE

Use a drain pan to capture hydraulic fluid in hoses. Dispose of hydraulic fluid in accordance with local

policy and ordinances. Ensure all spills are cleaned up.

Tag hydraulic hoses and note position of fittings to ensure correct installation.

Replacement of hydraulic hoses to and from pump and cab tilt cylinder is the same.

Open pump cover. Disconnect hose (4) from elbow (3) at bottom (pull) port of pump (1). Disconnect hose (5) from

elbow (2) at top (push) port.

If damaged, remove elbows (2 and 3) from pump (1).

PUSH PORT

PULL PORT

0126 00-2