|
|
![]() TM 9-2320-312-24-1
HEADLIGHT ADJUSTMENT
THIS WORK PACKAGE COVERS
Adjustment
INITIAL SETUP
Maintenance Level
Tools and Special Tools
Tool kit, general mechanic's (Item 35, WP 0166 00)
Unit
Shop equipment, common no. 2 (Item 29, WP 0166
MAC Reference
Personnel Required
Group 170
Two
RPSTL Reference
References
TM 9-2320-312-10
Group 170, Figure 17
NOTE
Perform adjustment procedures with vehicle on a flat surface and without any load on vehicle.
Ensure that all vehicle tires are inflated to 120 psi (827 kPa).
ADJUSTMENT
1.
At front bumper of vehicle, use measuring tape to determine center of vehicle.
2.
Place a vertical mark on bumper at center of vehicle.
3.
Drive up to a light-colored wall with both front lifting brackets of bumper almost touching wall and bumper parallel to
wall. Front wheels must be facing straight ahead.
4.
Transfer vertical mark on bumper to wall.
5.
Back up vehicle in a STRAIGHT line away from wall until vehicle is 25 ft (7.6 m) from wall. Apply parking brake and
shut down engine (TM 9-2320-312-10).
6.
Extend mark on wall upward approximately 36 in (91.4 cm) and also downward to floor. This line is vehicle's center-
line.
7.
On vehicle center line, measure upward 48 in (121.9 cm) from floor. Make a horizontal line parallel to floor.
8.
Determine headlamp centers by measuring outward 29.5 in (74.9 cm) on each side of vehicle center line. Mark head-
lamp centers.
9.
With environment sufficiently dark, switch LOW-BEAM headlights on (TM 9-2320-312-10).
10.
Note area of highest headlight intensity on wall.
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |