 |
|||
|
|
|||
|
Page Title:
CAGE AND UNCAGE BRAKES - CONTINUED |
|
||
| ||||||||||
|
|
 TM 9-2320-312-10
OPERATION UNDER UNUSUAL CONDITIONS - CONTINUED
0006 00
CAGE AND UNCAGE BRAKES - CONTINUED
d.
Insert cross-pin end of release stud (2) into opening where cap (3) was removed.
e.
To engage cross-pin, rotate release stud (2) turn clockwise until cross-pin end goes into slot inside of spring
chamber (6). Cross-pin is properly engaged if it does not pull out or rotate when pulled.
f.
Install washer (5) and nut (4) on release stud (2). Thread nut all the way to chamber.
g.
Install cap (3).
h.
Tighten nut (4) with a hand wrench until spring is fully caged and brakes are fully released.
i.
Repeat steps b-h to cage spring on other rear airbrake chamber.
2.
Uncage Brakes.
a.
Ensure wheels are blocked.
b.
Remove cap (3).
c.
Remove nut (4) and washer (5) from release stud (2).
d.
Turn release stud (2) to left turn and remove release stud from spring chamber (6).
e.
Insert release stud (2) into stowage pocket (1) and install washer (5) and nut (4) on release stud.
f.
Reinstall cap (3).
g.
Repeat steps b-f to uncage spring on other rear airbrake chamber.
2
3
1
2
4
5
6
5
4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals