|
| |
TM 9-2320-304-14&P
5-239
Direct Support and General Support Maintenance (Cont)
NOTE
·
Right and left arm assemblies are
installed the same. Right side is
shown.
·
Shim is 0.06 in. (1.5 mm) thick. Add
one shim per every gap between
retaining ring and bottom edge of
roller bracket.
·
Only add shim(s) if gap between
retaining ring and bottom edge of
roller bracket exceeds 0.06 in.
(1.5 mm).
(69) Install pivot pin (108) and retaining
ring (109).
(70) Measure distance between retaining
ring (108) and roller bracket (67).
(71) Determine amount of shim(s) (110)
required and remove retaining
ring (109) and pivot pin (108) from
roller bracket (67).
Change 1
|
