|
| |
TM 9-2320-304-14&P
5-234
Direct Support and General Support Maintenance (Cont)
5-43. CONTAINER HANDLING UNIT (CHU) KIT INSTALLATION (CONT).
WARNING
Adhesives, solvents, and sealing
compounds can burn easily, can give
off harmful vapors, and are harmful
to skin and clothing. To avoid injury
or death, keep away from open fire
and use in a well-ventilated area. If
adhesive, solvent, or sealing
compound gets on skin or clothing,
wash immediately with soap and
water.
(33) Apply antiseize compound to
CHU pivot pin (52).
(34) Install CHU pivot pin (52), two washers (49), and two snap rings (53).
(35) Remove lifting device from lift hook (47).
WARNING
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors,
and are harmful to skin and clothing. To avoid injury or death, keep away from open fire
and use in well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or
clothing, wash immediately with soap and water.
(36) Apply sealing compound to threads of
screw (54).
(37) Install screw (54) and axle stop (55) on
rear guide (56).
WARNING
Rear guide assembly weighs 70 lbs. (32 kg).
Attach lifting device to prevent possible
injury to personnel.
(38) Attach lifting device to rear guide (56).
(39) Soldier A position rear guide (56) on
right-side frame rail (2). Soldier B
install two lockwashers (57) and
screws (58).
(40) Install screw (59), washer (60), and
locknut (61) on rear guide (56).
(41) Install four locknuts (62) and
screws (63) on rear guide (56). Tighten
screws.
(42) Remove lifting device from rear
guide (56).
Change 1
|
