|
| |
TM 9-2320-304-14&P
5-135
Direct Support and General Support Maintenance (Cont)
d. Installation.
WARNING
Compression frame weighs 800 lbs. (363
kg). Attach suitable lifting device prior to
removal to prevent possible injury to
personnel.
(1) Attach lifting device to compression
frame (1).
(2) Install eight compression frame
spacers (2).
(3) Using lifting device, lower compression
frame (1) onto truck and position for
installation.
NOTE
Left and right side screws are installed the
same way. Left side is shown.
(4) Position three screws (3) and
locknuts (4) on each side of compression
frame (1) and truck.
WARNING
Adhesives, solvents, and sealing
compounds can burn easily, can give off
harmful vapors, and are harmful to skin
and clothing. To avoid injury or death,
keep away from open fire and use in a
well-ventilated area. If adhesive, solvent,
or sealing compound gets on skin or
clothing, wash immediately with soap and
water.
NOTE
Install spring washers in pairs with no two
pairs in the same direction.
(5) Apply sealing compound on threads of three screws (5).
(6) Install washer (6) and six spring washers (7) on three screws (5).
(7) Position three front screws (5) with washers (6) and spring washers (7) up through truck and
compression frame (1), and then install two spring washers (7) and locknut (8) on screw (5).
(8) Repeat steps (4) through (7) for right side.
(9) Tighten locknuts (8) to 75 lb-ft. (102 NSm).
(10) Tighten locknuts (4) to 410 lb-ft. (556 NSm).
(11) Repeat steps (8) and (9) for right side.
(12) Remove lifting device from compression frame (1).
|
