|
| |
TM 9-2320-304-14&P
5-112
Direct Support and General Support Maintenance (Cont)
5-24. LOAD HANDLING SYSTEM (LHS) MAIN FRAME REPAIR (CONT).
(4) Remove four locknuts (5), lockwashers (6), and bulkhead fittings (7) from main frame (2).
Discard locknuts.
c. Cleaning/Inspection.
WARNING
·
Drycleaning solvent (P-D-680) is TOXIC and flammable. Wear protective goggles,
face shield, and gloves; use only in a well-ventilated area; avoid contact with skin,
eyes, and clothes; and do not breathe vapors. Keep away from heat or flame. Never
smoke when using solvent. The flashpoint for Type III Drycleaning Solvent is 200_F
(93_C). Failure to do so may result in injury or death to personnel.
·
If personnel become dizzy while using cleaning solvent, immediately get fresh air
and medical help. If solvent contacts skin or clothes, flush with cold water. If
solvent contacts eyes, immediately flush eyes with water and get immediate medical
attention.
(1) Clean all metal surfaces with drycleaning solvent (P-D-680).
(2) Inspect main frame for cracked welds or damage. Replace or repair as necessary.
(3) Inspect bushing for wear. Replace if pivot pin has worn through bushing surface and metal is
showing through.
|
